If the PSU is modular, install the necessary power contacts. There you will find special holes that should line up with those on the power supply. Regardless of the installation method, always look down the fan and the switch towards the rear of the case. On the other hand, more dust gets into it, so a fine mesh should be installed inside the case. The latter is better, since it draws in air from below, and not from a hot case. Its installation depends on the case, or rather, on whether it has a top or bottom installation. For example, usually the manufacturer specifies 2 and 4 connectors. If the motherboard supports 4 or more brackets, you need to check in the instructions for the motherboard which connector is better to insert. In the RAM, in the contact area, there is a small groove that will help insert the memory in the correct direction. The maximum supported size, frequency and type of memory can be found in the characteristics of the motherboard. For new systems, these will be DDR4 strips, but if processors of the latest generations are not used, then perhaps DDR3 will do. The next step in assembling the system unit with your own hands will be the installation of RAM. In this case, you need to check the compatibility with your socket if you are using Intel, but AMD has not changed the mount since the days of their first processors. If you want to overclock the processor or build a quiet system unit, you will need to buy a more efficient cooling system. It is only important to take care of a good air flow. It is enough to apply thermal paste, apply cooling and hook the side metal clips in the center of the plastic base.Ī standard cooling system is sufficient for most applications. On motherboards under AMD processors immediately installed a plastic mount for the cooler. It is necessary to insert the legs of the cooling system into them. You can see 4 holes around the processor. The cooling system itself will distribute it over the surface. It is not necessary to apply a lot, one drop is enough exactly in the center. Cooling systemīefore installing the cooling system, it is necessary to apply thermal paste to the metal cover that protects the processor crystal. We check that the processor is properly seated in place, and then we lower and fix the lever. Next, we put the processor so that the triangle in the corner coincides with the one on the socket. It is also necessary to lift the lever on the side. When assembling the system unit with our own hands, we act carefully: the processor is pressed tightly, and it will take a little effort, but we must act carefully and avoid skewing or incomplete installation.ĪMD processors are installed in a similar manner. Next, lower the lever and fix it in place. Make sure the processor is firmly seated in place, not wobbling or skewed. For correct positioning, small triangles are printed on the processor and socket in the corner. Then we take out the protective plastic cover and install the processor with the contacts down. If you have Intel, you need to slide the lever out from under the latch and then lift it up. Installation, for greater convenience, is carried out outside the case. You can find out this information in the characteristics of the components. When buying a processor and motherboard, it is important to check their compatibility.
We check the specifications for the support of the required motherboard format. What is needed for assemblyīefore assembling the system unit yourself, you will need to prepare the following: In fact, this is a fairly simple process: it is simply impossible to connect something wrong thanks to the efforts of the manufacturers. Further, following the rules and following the order of actions, it is necessary to collect system unit.
Msi interceptor ds b1 wired jet.com full#
It is important to choose the right components, ensuring full compatibility and the optimal combination of characteristics. The way out will be the self-assembly of the system unit.
In addition, many may be frightened off by the extra charge for a ready-made package. It is not always possible to find a ready-made computer that fully meets the requirements in electronics stores.